The are various equipment used while installing a home appliance. Some of these are:
- Rotary tubing or pipe cutter
- Tubing bender
- Power drill
Rotary Tubing or Pipe Cutter
Pipe cutter and rotary tubing, both have a similar design. They have a structure like a C-section clump, one side stationary support and the other side adjustable support mounted at the end of an adjustment screw. These cutters have a roller wheel and a cutting wheel, where one is movable and the other is stationary. They are usually used to cut the tubes/pipe used during installation of a water purifier.
Usage
To use the tube/pipe cutter follow the given steps:
- Open the tool. a. Loosen the screw. b. Retract the cutting wheel or rollers
- Slide the tubing or pipe into the tool.
- Turn the adjustment screw to bring the cutting wheel and the roller wheels in contact with it.
- Rotate the tool around the clamped tubing or pipe to begin the cutting process
- Tighten the adjustment screw after one full rotational pass to engage the cutting wheel deeper into the tubing or pipe.
- Debus inner edge of the current, as soon as the tubing or pipe is cut.
Tubing bender
An equipment used to provide consistent and accurate bends on various tubes, such as steel tubes, copper tubes and aluminum based tubes, is known as a tubing bender. This equipment can be used for bending pipe of any size. They are usually used to bend the tubes/pipe which may need to be connected to large pipes.
This equipment is also used to bend the tubes/pipe which may need to be connected to small pipes during installation of a water purifier.
Manual tubing requires minimal training. These tubes can be used to bend the pipe up to 180° in a finished form.
Usage
Steps to be followed while using a tubing bender are:
- Choose an appropriate tubing bender Ｏ Use an appropriate tool for the particular
- Set up the tubing bender: Ｏ The bending tool consists an adjustment dial that should be set based on the radius that is desired for the tube as well as the overall number of degrees required in the bend.
- Mark bend directions and reference points : Ｏ Mark the tide with a reference longitudinal line. Ｏ The line should be towards the direction that is opposite to the bend direction desired.
- Align and insert the tube into the bender: Ｏ Swing up one bending arm to insert the tube into the bending die, ensuring that the reference marks are visible. Ｏ Lower the second arm using latch mechanism to hold the tubing involved while allowing for minor adjustments.
- Start the bending process: Ｏ Firmly grip the roll support arm while bringing it down until the required degree mark is reached on the bending die. ＯBe careful for any spring back during the process.
- Disengage the tube from the bender: Ｏ Unlatch and disengage the tube from the die by lifting up the roll support arm, now remove the finished tube from the tube bender.
Power Drill
The power drill is used for fastening various objects together using fasteners or boring holes into various objects. "Bits" and "drill bits" can be attached to it to match whatever screw it is to be used for, allowing to drill holes into various things.
Power drill is generally used for:
- Screwing jobs, for example in construction activities or during assembly of parts of big mavhineries or appliances such as a water purifier, mixer or a microwave oven.
- Drilling holes into various objects such as a wall or another surface to install an appliance, such as a water purifier, at a stationary posution
- Dentistry, but the power drill is of a different kind.
Usage
To use the power drill, follow the given steps:
- Loosen
- Put the bit into the chuck
- Tighten. Ensure it is properly done.
No comments:
Post a Comment