Installation of RO Water Purifiers

The installation process begins with site preparation. The recommended site preparation steps are shown in the following figure:

• Ensure single phase connection is within 3m of the point of installation 
• Ensure raw water supply is within 3m
• Ensure raw water supply tank is at least 10 feet above the purifier 
• Ensure there is a sink near the purifier
• Ensure waste water drain is within 3m
• Ensure enough space is there as per the dimensions of the purifier 

Installation Procedure 

The following steps should be performed when installing a wall mounted RO water purifier:

1. Disconnect the water supply line from the normal tap water. 
2. Mark screw locations at same horizontal level on the wall. 
3. Screw in two self -taping screws into the marked positions. 
4. Hang the purifier with the help of wall mounting screws present at the back of the purifier. 
5. Fix the SS ball valve to the port of 3-way connector. 
6. Connect the raw water supply to the 3-way connector:                                       a. Connect the threaded end of the connector to the raw water supply.        b.  Connect the other end to a tap, if     required. 
7. The left side of the purifier has a lower pushfit elbow fitting labeled as WAYER IN. 
8. Take the white pipe which is for raw water supply:                                               a. Connect one end to the a SS ball     valve.                                                           b.  Connect the other end to the   WAYER IN fitting. 
9. The left side of the purifier has an upper pushfit elbow fitting labeled as REJECT WATER 
10. Take the blue pipe which is for reject water.                                                           a.  Connect one end to the REJECT   WATER fitting.                                           b. Leave the other end in the drain. 
11. Open the ssball to start the flow of water into the purifier. 
12. Ensure that the filters are soaked in water before connection the power supply.