Straight-through cables:- CAT 5 UTP cabling usually uses only four wires when sending and receiving information on the network. The four wires of the eight that are used wires 1,2,3 and 6.figure 1-18 shows 6 meaning of the pins on a computer and the pins on a hob(or switch),which is what you typically will be connected the computers to. When you configure the wire for the same pin at either end of the cable, this is known as a straight- through cable.
Different UTP category cabling
You will notice in the figure that wires 1and 2 are used to transmit data (TX) from the computer, while wires 3 and 6 are uesd to the receive information (RX) on the hob via wires 1 and 2.This
You will notice in the figure that wires 1and 2 are used to transmit data (TX) from the computer, while wires 3 and 6 are uesd to the receive information (RX) on the hob via wires 1 and 2.This
No comments:
Post a Comment